Charnwood MC1210 COMING SOON

SKU
MC1210
Out of stock
£355.00
Overview

Micro clean air filters are designed to remove airborne dust particles from the air in the workshop. They are compact, lightweight and very quiet in operation. They are capable of running for long periods of time while you work, and for best results, left running for a period after the dust producing activity has finished.

When in operation they quietly clean and filter the air, trapping dust particles in the filter medium. Most woodworkers will have had experience of leaving the workshop nice and tidy, but then the next day discovering a layer of dust has settled on all horizontal surfaces overnight. The micro clean is designed to prevent completely or drastically minimise that phenomenon.

An air cleaner should be used in conjunction with a dust extractor for maximum dust control.

It is recommended that the air in the workshop is filtered by the micro clean 10 times per hour (minimum recommended level is 6 times per hour). Measure the three dimensions to calculate the cubic volume of your workshop, then check which size of air filter is most suitable.

Manufactured in the UK using high quality components throughout. The filter is made of EU4 grade, non-woven, thermally bonded polyester fibres, which means it will filter out 95% of all dust at 2 microns or larger, 80% of dust down to 1 micron and 65% of dust down to 0.4 micron. The filters are low cost and very easy to replace. As a general rule-of thumb filters should be regularly checked and replaced every 6-12 months. The highly reliable motors are Swiss made to a very exacting standard. Thermally protected and most important to woodworkers they are spark proof, so less chance of dust combustion. Ingress protected to IP44 standard.

MC1210 has an airflow rate of 1200 cubic metres per hour. Therefore it is suitable for a workshop with a volume of up to 120 cubic metres, roughly equal to a triple garage. For example: Floor area 9m (30’) x 6m (20’) x height 2.2m (9’).

Designed to be suspended from the ceiling in the centre of the room or located directly overhead of where the dust is produced.

Dust contaminated air is drawn into the bottom and side of the filter, through the filter media which traps the dust within, then clean air is expelled out through the vents around the top of the unit.

Supplied with hanging chain, 1m power cable and plug.

MC1210 SPECIFICATION

Motor 90w, 240v
Flowrate 1200m3/hour
Max. Workshop Size 120m2
Filtration Efficiency 95% @ 2 micron
  80% @ 1 micron
  65% @ 0.4 micron
Dust Holding Capacity 500g/m2
Noise Level 68db
Dimensions (WxDxH) 305 x 305 x 280mm 
Weight

8kg

Rating 

Hobby

Warranty

1 Year

Write Your Own Review
You're reviewing:Charnwood MC1210 COMING SOON